76
--rx_amplitude <value>
Set Module Rx Output Amplitude
[0(100-400mV),1(300-600mV),2(400-800mV),3(600-1200
mV)]
--margin
Read the SerDes eye margins per lane
--measure_time <time>
Measure time in seconds for single eye [10, 30, 60, 90,
120, 240, 480, 600 and 900] (Optional - Default 60 for
PCIe and 30 for Network ports)
--eye_select <eye_sel>
Eye selection for PAM4 [UP, MID, DOWN, ALL] (Default
ALL)
--lane <lane_index>
Run eye for specific lane index (Default all lanes)
--rx_error_injection
Enable the RX link deterioration
--mixer_offset0 <value>
Fine change to the center of the eye [0x0 to 0x7ff]
--mixer_offset1 <value>
Coarse change to the center of the eye [0x0 to 0x3ff]
--show_mixers_offset
Show mixer offset 0 and mixer offset 1
--rx_fec_histogram
Provide histogram of FEC errors. The result is divided to
bins. Each bin is holding different number of errored bit
within FEC protected block
--show_histogram
Show FEC errors histogram
--clear_histogram
Clears FEC errors histograms
--yes
Non-interactive mode, answer yes to all questions
Examples:
Get info of <device>, <port_number>:
mstlink -d <device> -p <port_number>
Get info of <device>, <port_number> and BER Counters:
mstlink -d <device> -p <port_number> -c
Get info of <device>, <port_number> and Transmitter Parameters:
mstlink -d <device> -p <port_number> --show_serdes_tx
Configure Port State:
mstlink -d <device> -p <port_number> --port_state UP
Configure Port Speeds:
mstlink -d <device> -p <port_number> --speeds 25G,50G,100G
