32
•
•
•
-blank_guids
Burn the image with blank GUIDs and MACs (where applicable). These values can be
set later using the "sg" command (see details below).
Commands affected: burn
-clear_semaphore
Force clear the flash semaphore on the device. No command is allowed when this
flag is used.
NOTE: May result in system instability or flash corruption if the device or another
application is currently using the flash. Exercise caution.
-d[evice] <device>
Device flash is connected to.
Commands affected: all
-dual_image
Make the burn process burn two images on flash (previously default algorithm).
Current default failsafe burn process burns a single image (in alternating locations).
Commands affected: burn
-flash_params
<type,log2size,num_of
_flashes>
Use the given parameters to access the flash instead of reading them from the flash.
Supported parameters:
Type: The type of the flash, such as: M25PXxx, M25Pxx, SST25VFxx,
W25QxxBV, W25Xxx, AT25DFxxx, S25FLXXXP
log2size: The log2 of the flash size
num_of_flashes: the number of the flashes connected to the device
--flashed_version
When specified, only flashed fw version is fetched
Commands affected: query
-guid <GUID>
GUID base value. 4 GUIDs are automatically assigned to the following values:
guid -> node GUID
guid+1 -> port1
guid+2 -> port2
guid+3 -> system image GUID
NOTE: port2 guid will be assigned even for a single port HCA - The HCA ignores this
value.
Commands affected: burn, sg
-guids <GUIDs...>
4 GUIDs must be specified here. The specified GUIDs are assigned to the following
fields, respectively: node, port1, port2 and system image GUID.
NOTE: port2 guid must be specified even for a single port HCA. The HCA ignores this
value. It can be set to 0x0.
Commands affected: burn, sg
-h[elp]
Prints this message and exits
-hh
Prints extended command help
-i[mage] <image>
Binary image file.
Commands affected: burn, verify
-log <log_file>
Prints the burning status to the specified log file
