UB–12R OWNER'S MANUAL
NU–VU® FOOD SERVICE SYSTEMS
MENOMINEE, MICHIGAN 49858
(800) 338-9886
SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322
page
17
99-MINUTE DIGITAL TIMER:
A. Set the Power Switch to the
ON
position. The interior lights of the oven should
illuminate, and the Timer should activate (the LEDs in the display window will show
000
).
B. Press either the UP or DOWN
Time Set
keys to enter the desired time in minutes and
seconds. The set time will appear in the display window.
C. Start the Timer by pressing the
Start/Stop
key once. The Timer will count down one
second at a time, flashing the remaining time in the display window. Pressing the
Start/Stop
key a second time will halt the Timer; the time remaining in the cycle is shown
in the display window. This time can now be edited by using the
Time Set
keys. Pressing
the
Start/Stop
key again will restart the Timer.
D. When the set time expires the display window will flash
000
and an alarm will sound for
30 seconds; the operator can silence the alarm earlier by pressing the
Start/Stop
key. After
the Alarm is turned OFF the Timer will automatically reset itself to the last entered time.
Pressing the
Start/Stop
key will restart the Timer for the previously entered time.
99-MINUTE TIMER OPERATIONAL NOTES:
•
The entered time changes by 1 second each time you press a
Time Set
key. Holding either
key down changes the time by
1-second
increments for the first 35 seconds of change,
10-
second
increments for the next 8 minutes of change, and
1-minute
increments for the
remainder of the change to a maximum set time of 99 minutes and 59 seconds (
99:59
in
the display window). Releasing the
Time Set
key restores the 1-second increment of
change.
•
The time setting can only be edited when the Timer is not running.
•
A Timer can be reset at any time during the cooking cycle by pressing the
Start/ Stop
key
and either
Time Set
key; the first "click" will return the Timer to its original set time. The
set time can now be edited, or the Timer can be restarted to count down from the original
set point.
•
This digital Timer contains a short-term memory chip to prevent the loss of a Timer
setting because of an accidental shut-down of the unit. The Timer will recall the last
entered setting when the unit is restarted.
IMPORTANT: YOUR OVEN WILL NOT HEAT IF THE 24 HOUR TIMER IS
SET TO OFF. THE OVEN TEMPERATURE CONTROL WILL FUNCTION
ONLY WHEN THE 24 HOUR TIMER IS SET FOR A RUN TIME BETWEEN
"1" AND "24". THE HOLD CONTROL WILL FUNCTION ONLY WHEN THE
24 HOUR TIMER IS SET TO "0".
This page was created using BCL ALLPDF Converter trial software.
To purchase, go to
http://store.bcltechnologies.com/productcart/pc/instPrd.asp?idproduct=1
