UB–12R OWNER'S MANUAL
NU–VU® FOOD SERVICE SYSTEMS
MENOMINEE, MICHIGAN 49858
page
10
SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322
(800) 338-9886
D. The two-part compression fitting (tapered collar and nut) is placed approximately 1" onto
the tubing so that the collar is inside of the nut and the threaded opening of the nut is
toward the intake fitting.
E. Push the tubing all the way into the Water Intake Fitting (as far as it will go) and hold it
there while you thread the compression nut onto the Water Intake Fitting. Tighten the
compression nut with an open-end wrench,
but do not over–tighten the fitting!
If the joint
leaks when tested and further gentle tightening does not stop the leak, the two-part
compression fitting must be replaced.
Careful attention to these simple procedures will help to ensure an installation without leaks. If you
have any questions or problems please call NU–VU®'s Service Department at (800) 338–9886.
This page was created using BCL ALLPDF Converter trial software.
To purchase, go to
http://store.bcltechnologies.com/productcart/pc/instPrd.asp?idproduct=1