Nuvo Navigator Lift 150 Dual, Руководство по установке

Страница: 70 / 96

70
14 Mounting the Canopy, Cover Caps and the Cover Panels
1568911, Edition 2019-04, Version 0
EN
Figure 51: Mounting the rear side panels to the motor arm
14.5 Mounting the rear side panels to the motor arm
(See "Figure 51")
The Figure shows the motor arm
4
. The installation procedure for the
extension arm with motor arm
5
or the XL extension arm with motor arm
5
version is identical.
The Figure shows a simplified representation with only the motor arm
4
without cables.
1. Place the first side cover panel① and insert 3 plastic pins③ into the
holes② in the motor arm.
• Make sure that the cover plate⑥ protrudes into the guide⑤ of the
side cover panel①.
2. Place the second side cover panel and insert 3 plastic pins③ into
the holes② in the motor arm.
• The cover plate⑥ must protrude into the guide⑤ of the side cover
panel① and the 3 locking devices④ on the 2 side cover panels must
engage with each other.
3. Check that the side cover panels are securely in place:
•
The 3 locking devices④ must be connected with each other.
• The cover plate⑥ must slide in the guides⑤ of the side cover pan
-
els.
• The side cover panels must engage tightly with each other without
gaps.
Figure 52: Mounting the lower, rear covers to the motor arm
14.6 Mounting the lower, rear covers to the motor
arm
(See "Figure 52")
The Figure shows the motor arm
4
. The installation procedure for the
extension arm with motor arm
5
or the XL extension arm with motor arm
5
version is identical.
The Figure shows a simplified representation with only the motor arm
4
without cables.
1. Hold the cover② in the angle illustrated in the Figure.
2. Insert the joint④ of the rear, lower cover② into the 2 mounting
fixtures③ in the upper side cover panels①.
3. Fold up the cover② such that the 2 latches⑤ snap into place.
4. Check that the cover ② is securely in place:
•
The guides⑥ of the cover② must sit in the side cover panels①.
• The cover② must sit in the side cover panels① without gaps.
5. Insert 2 Allen countersunk screws M3 x 10mm⑦ into the
openings⑧ in the cover② and tighten them.