Nuvo Navigator Lift 150 Dual, Руководство по установке

Страница: 62 / 96

62
12 Connecting the Supply Cables and Hoses
1568911, Edition 2019-04, Version 0
EN
Figure 40: Connecting the earthing cables
12.3 Connecting the earthing cables
(See "Figure 40")
The Figure shows a simplified illustration of the interface plate
1
without
extension arm and cables, etc.
1. Observe the safety instructions in Chapter 12.1 on Page 60.
2. Cut all green/yellow earthing cables (2.5mm² and 10mm²) to the
correct length.
3. Route the earthing cables through the strain relieving mechanism
and connect them to the series terminals 4mm² or 10mm² on the
earthing terminal block① on the interface plate
1
.
4. Check that the earthing cables are securely in place in the strain re
-
lieving mechanisms②:
• All earthing cables must be securely installed in the strain relieving
mechanisms②.
Figure 41: Installing the voltage selection plug for the 120V /
230V power supply
12.4 Installing the voltage selection plug and con
-
necting the power cables
12.4.1 Installing the voltage selection plug for the 120V / 230V
power supply
(See "Figure 41")
1. Observe the safety instructions in Chapter 12.1 on Page 60.
Power supply failure
If the 120 V or 230 V voltage selection plug is incorrectly
assigned to the existing power supply, the internal fuse
blows and the motor arm becomes inoperable:
• When installing the corresponding voltage selection
plug, make sure that it is correctly assigned to the
existing power supply.
• If the fuse blows, it can be replaced as described in
Chapter 12.4.2 on Page 63.
1. If required, swing the electronic unit out of the motor arm as de
-
scribed in Chapter 11.3 on Page 47.
2. Check the power supply at the installation site and plug the correct
voltage selection plug③ onto the socket② of the main board①:
• For a 100-120V power supply, use the 120V voltage selection plug
• For a 220-240V power supply, use the 230V voltage selection plug
NOTICE