Nuvo Navigator Lift 150 Dual, Руководство по установке

Страница: 25 / 96

25
1568911, Edition 2019-04, Version 0
EN
6 Mounting Threaded Bolts to the Interface Plate
Figure 9: Cutting and installing the threaded bolts for the Sin
-
gle / Duo interface plate on the raw ceiling
6.1 Mounting situation: Mounting the interface plate
to the raw ceiling without intermediate ceiling
6.1.1 Versions
(See "Figure 9")
The following Figures illustrate the interface plate
1
, Single (round
shape), for installing the motor arm and motor arm with extension arm
versions.
The steps required for installation on the interface plate
1
Single
(squared shape) are identical.
6.1.2 Cutting the threaded bolts to length
(See "Figure 9")
If a Single / Duo interface plate
1
is mounted to the raw ceiling, the
6 (Single version) or 12 (Duo version) threaded bolts M16 x 330mm③
must be cut to length.
The Single / Duo canopy
3
with attachment to be mounted later is flush
with the raw ceiling and covers the ceiling tube flange.
1. For a canopy
3
which is 260mm high the 6/12 threaded bolts
M16 x 330mm③ must be cut to 240mm.
2. Slightly deburr the 6/12 threaded bolts M16 x 330mm① in order to
ensure maximum thread engagement into the interface plate
1
.
6.1.3 Mounting the threaded bolts
(See "Figure 9")
1. Screw 1 hexagonal nut M16② each onto the 6/12 threaded bolts
M16③ and then place 1 spring ring① each.
Pendant system dropping
If the threaded bolts M16③ are not completely screwed
in, they may break out of the interface plate
1
and cause
the pendant system to drop:
• Make sure that all shortened threaded bolts M16③
are completely screwed into the interface plate
1
up
to the end stop on the raw ceiling.
Pendant system dropping
The pendant system can drop if the fixing elements have
not been properly tightened:
• Tighten all hexagonal nuts M16② with a tightening
torque of 195Nm.
2. Check that the shortened threaded bolts M16③ are securely in
place at the correct distances to each other:
• The threaded bolts M16③ must be completely screwed into the
interface plate
1
.
• The 6/12 hexagonal nuts M16② must be tightened to 195Nm.
3. Continue the installation as described in Chapter 6.1.4 on Page 26.

WARNING