Nuvo Navigator Lift 150 Dual, Руководство по установке

Страница: 45 / 96

45
1568911, Edition 2019-04, Version 0
10 Mounting Optional Accessories
EN
Figure 29: Mounting the brake indicators
10.2 Mounting the brake indicators (for retrofit only)
(See "Figure 29")
Upon delivery of the system from the factory the following optional
accessories are pre-assembled:
The Figure shows the extension arm with motor arm
5
. The installation
procedure for the XL extension arm with motor arm
5
version is identi
-
cal.
The brake indicators
9
are mounted to the swivel or brake points of the
motor arm
4
or the extension arm with motor arm
5
or the XL extension
arm with motor arm
5
. Four brake indicators
9
are mounted to the Dual
arm version, whereas 2 brake indicators are mounted to the Single arm
version.
1. Gently disengage the 2 / 4 pre-assembled plastic covers① on all 4
latches②, remove them and keep them in a safe place.
2. Plug 1 power cable connector③ onto the connector socket⑦ of the
lighting board⑤.
Colour code of the lighting boards⑤:
• Upper bearing = green (No. 1546534)
• Intermediate bearing = blue (No. 1546650)
3. Route the power cable③ through the hole⑥ (see arrow) into the ex
-
tension arm / motor arm.
• Make sure that the plugs and the power cable③ are not damaged.
• The power cable③ must sit entirely in the extension arm / motor arm.
4. Hook the lighting board⑤ at the bottom side into the mounting
aperture④ and gently push it in until it audibly snaps into place.
• Do not push the lighting board⑤ into the mounting aperture④ with
force.
5. Check that the lighting board⑤ is securely in place:
•
The lighting board⑤ must sit in the mounting aperture④ without
being wedged.
NOTE – Colour code of the plastic covers
Navigator Lift
™
pendant system – Dual arm:
• The upper plastic cover① is green
• The lower plastic cover① is blue
Navigator Lift
™
pendant system – Single arm:
• The plastic cover① is green
6. Gently push the 2 / 4 plastic covers① into the mounting aperture④
until the 4 latches② audibly snap into place.
7. Check that the plastic covers① are securely in place:
•
The plastic covers① must sit in the mounting aperture④ without
being wedged.