Set Up the KXTA 824 for Built In DISA Auto Attendant
Step 1. Set the CO Lines for DISA/AA Service
Programming must be done from extension 101
Leave the handset in the cradle and press the PROGRAM button
Dial *#1234 (STAR POUND 1 2 3 4)
Dial 414
Press the SP-PHONE button
Dial * (STAR) Sets all lines for DISA or dial a specific CO for individual control.
Press the AUTO ANS/MUTE button until the display flashes “CO *:DISA:OGM-“
Dial 1
Press the AUTO DIAL/STORE button
Press the HOLD button
Step 2. Assign Dialed Digit to Extension Jacks
Dial 501
Press the SP-PHONE button
Dial 1
Press the AUTO ANS/MUTE button until the display reads “1:Jack-“
Dial the jack number (01, 02 etc.)you want the call to go to when the caller dials 1.
Press the AUTO DIAL/STORE button to save your setting.
Press the SP-PHONE button and the display will change to “2:Not Stored”
Dial the jack number you want the call to go to when the caller dials 2.
Press the AUTO DIAL/STORE button to save your setting.
Repeat the steps until you have entered all jack locations you need.
Press the HOLD button when done.
Example:
Dial 1 for Jack 03
Dial 2 for Jack 06
Dial 3 for Jack 02
If unused, be sure to assign Dial 7 for Jack 01 to prevent Modem Access.
Special Note:
If unused, be sure to assign Dial 9 and Dial 0 to Jack 01 (Receptionist)
Otherwise, Dial 9 or Dial 0 may allow a caller to go back out on another line.
Note:
CPC Disconnect Service (>250ms) from Telco is required for abandoned calls.
