Nuvico MP-OV22N, Руководство по установке

Страница: 12 / 60

12
2. Installation and Configuration
CAUTION 1:
•
Before installing mounting bracket to surface, pre-adjust the four mounting screws "A”
(Figure F) on the base of the dome camera to best match the mounting bracket locked
position.
•
Unscrew the locking screw on the side of the dome's base and fit the tab of the mounting
bracket into the locking slot.
•
Screws "A" (Figure F) should not be too tight or too loose when the dome is in the locked
position. After setting the proper positions of screws "A" (Figure F), remove the mounting
bracket and install it to the proper surface.
•
If it is too difficult to lock the dome in position after the mounting bracket has been
installed readjust the screws "A" (Figure F) by unscrewing them slightly. Then, try
installing the dome camera again.
CAUTION 2:
Set the termination and ID address of the dome before final installation as described at
section 2.