Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in U.S.A., Rev. 05/2001, Part No. 88950
One Year Limited Warranty
WARRANTY OWNER:
NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period
of one (1) year from the date of original purchase.
THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
During this one year period,
NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES, FILTERS, DUCT, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES
FOR DUCTING. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident,
improper maintenance or repair (other than by NuTone), faulty installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the one year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty
lasts, so the above limitation may not apply to you.
NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS
WARRANTY. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH
PRODUCT USE OR PERFORMANCE.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the address stated below or telephone 1/800-543-8687, (b) give the model
number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present
evidence of the original purchase date.
Date of Installation
Builder or Installer
Model No. and Product Description
IF YOU NEED ASSISTANCE OR SERVICE:
For the location of your nearest NuTone Independent Authorized Service Center:
Residents of the contiguous United States
Dial Free 1-800-543-8687
Please be prepared to provide:
Product model number • Date and Proof of purchase • The nature of the difficulty
Residents of Alaska or Hawaii should write to:
NuTone Inc. Attn: Department of National Field Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599.
Residents of Canada should write to:
Broan-NuTone Canada, 1140 Tristar Drive, Mississauga, Ontario, Canada L5T 1H9.
Rev. 03/2001
FIGURE 4
GRILLE/LIGHT INSTALLATION
1.
Refer to Figure 4.
Open reflector on back of grille by depressing
latch and lifting up on reflector. Install one 100 watt maximum
Type A incandescent lamp. Note: reflector holds glass diffuser in
place. Be careful that diffuser does not drop out of grille. Close
reflector and snap into position.
2. Depress mounting springs on sides of grille and insert into slots
on either side of fan housing. Connect plug from reflector to the
three pin receptacle on the wiring compartment cover.
3. Press grille firmly into place against ceiling.
LAMP REPLACEMENT
1. Pull grille down from ceiling as far as the grille springs will allow.
Disconnect plug of reflector from the receptacle on the wiring
compartment cover. Depress the grille mounting springs and
remove the grille from the ceiling.
2.
Refer to Figure 4.
Place the grille on a table or counter top. Open
reflector by depressing latch and lifting up on reflector. Note:
Reflector holds glass diffuser in place. Be careful that diffuser
does not drop out of grille. Replace lamp with one 100 watt
maximum type A lamp. Close reflector and snap into position.
3. To remount grille, depress grille springs on either side of grille and
insert into slots in housing. Connect plug from reflector to the
receptacle on the wiring compartment cover. Press grille firmly
into place against ceiling.
