Nussbaum UNI-LIFT 3200 NT Plus ND, Инструкция по эксплуатации и документация

Страница: 32 / 54

Operating Instruction and Documentation
UNI-LIFT 3500 NT ND/ UNI-LIFT 3200 NT Plus ND
- 32 -
Correct equalization:
Situation:
One platform is higher than the other.
preparations/measures:
• Lower the lift as far as possible into the lowest position. Press button „lowering“.
pic.2
pic. 2: ball valves for the equalization of the lift.
• Remove the cover of the operation unit (back side)
• Raise the main lift on the highest end position. Pull ball valve KU1 and KU2 and press
button „Lifting “ once again. Put the ball valves into the start position again.
• Equalization of the wheel free lift:
Choose the wheel free lift (“RFH”) at the reversing switch (see pic.1, 4)
Lift the wheel free lift in the highest position.
Pull ball valve KU3 and press button „lifting or lowering“ until the platforms are on the
same height. Put the ball valve into the start position, again.
5.4 Change the position of the Turntable
• It is possible to enlarge (max.100mm) the distance between the sliding plate and the turn
table. This is necessary to reach the maximum wheel base distance of max.3240mm.
• Raise the lift on the top end position. Remove the 8 piece thumbscrews under the
platform.
• Lower the lift on approx. 800mm.
• Remove both Turntables. Rotate both Turntable to 180° and then position the Turntable
from the right side to the left side and the left turntable to the right side.
• Raise the lift on the top end position. Fasten the 8 piece thumbscrews under the platform,
again.
ball Valve
KU1
(main lift)
ball Valve
KU2
(main lift)
ball Valve
KU3 for the
wheel free
Pressure
switch