Nussbaum UNI-LIFT 3200 NT Plus ND, Инструкция по эксплуатации и документация

Страница: 41 / 54

Operating Instruction and Documentation
UNI-LIFT 3500 NT ND/ UNI-LIFT 3200 NT Plus ND
- 41 -
If you do not close the vent screws, trouble and disturbances of the lift will occur!
• Push button „lifting“ and drive the lift into the highest position. Repeat the procedure of
ventilation, if necessary.
• Check if the vent screws are closed.
• Push button „lowering“ and drive the lift into the lowest position. (While you lower the lift it is
possible that the oil-air mix makes sounds) .
9.4 Initiation
Before the initiation a security check must be performed. Therefore use form: First
security check.
If the lift is installed by a competent person, he will perform this security check. If the
operator installs the lift by himself, he has to instruct a competent person to perform the
security check.
The competent confirms the faultless function of the lift in the installation record and form for
the security check and allows the lift to be used.
Please send the filled installation record to the manufacturer after the installation.
9.5 Changing the installation place
If the place of installation shall be changed, the new place has to be prepared in according to
the regulations of the first installation. The changing should be performed in accordance with
the following points:
• Raise the lift on approx. 1000 mm.
• Remove the cover of the hydraulic tubes.
• Loose the dowels.
• Lower the lift in the lowest position.
• Loose the plug of the power supply.
• If necessary loose the hydraulic hoses only on the operating unit.
• If necessary use blind plugs to close the hoses.
• Disconnect the power supply.
• Transport the lift to its new place.
• Install the lift in accordance with chapter 9 “ Installation and Initiation”.
• Equalize and deaerate the lift!
Use new dowels, the used dowels can not be used anymore.
A security check must be performed before reinitiation by a competent person. Use
form “Regular security check”