Nussbaum UNI-LIFT 3200 NT Plus ND, Инструкция по эксплуатации и документация

Страница: 31 / 54

Operating Instruction and Documentation
UNI-LIFT 3500 NT ND/ UNI-LIFT 3200 NT Plus ND
- 31 -
• (Wheel free lift) Position the polymer supports under the pick-up points which are
described by the vehicle manufacturer. Do not lay them on edge! The vehicle might fall
down!
• Raise the lift. Press the button „lifting“.
• (Wheel free lift): Stop the lifting when the wheels are free to check the safe position of the
vehicle on the polymer pads.
• Lift the vehicle on the working height. Press the button „lifting“ .
pic. 1: operation unit
1 main switch
2 button „lifting“
3 button „lowering“
4 reversing switch main lift/wheel free lift
5.2 Lowering the vehicle
• Check the dangerous places of the lift and be sure that there are no objects or people in
the immediate area of the lift or on the lift.
• Choose between main lift/ wheel free lift (see pic.1, 4)
• Lower the vehicle to the working height or until the platform reaches the lowest point;
press the button „lowering“ .
• Observe the complete process.
• Before the main lift reaches the lowest position, it stops (approx. 120 mm).
Let off the „lowering”. Control the dangerous places. Press the button again. You hear an
acoustic signal until the lift reaches the lowest position.
• When the lift is in its lowest position, remove the polymer supports
(wheel free lift)
• Drive the vehicle out of the lift if the lift (main lift) is in the lowest position.
5.3 Equalization of the platforms
Because there are two independent hydraulic systems, differences between the two rails
should normally not appear when you operate the lift correctly.
Check possible mistakes before you equalize the two platforms (for instance a leakage of the
hydraulic system or another external mistake)
Equalize the rails only without load!
Before an equalization you have to remove any kind of load of the lift!
An equalization could be necessary when one side isn’t let down completely into the lowest
position or if the loads of the two rails are very different of each other, for example.