Nussbaum MCS 5500 ND WIRELESS, Руководство по эксплуатации

Страница: 21 / 57

Operating Instruction and Documentation
MCS 5500 ND WIRELESS
- 21 -
Bild 12: single-mode “lowering”
• Observe the complete process.
• When the lifts are in the lowest position the mobile lifts can be removed. Raise the MCS
with the hand lever (read chapter 5.1).
5.7 Axle-mode (only with 6 columns)
Before dismounting heavy parts (motor, axle, set of gears) check the center of gravity.
Otherwise a malfunction can lead it to damages or lead to danger for body and lives.
It is possible one MCS and the MCS at the opposite side to raise and to lower, together.
(axle-mode). This is necessary to dismounting heavy parts (motor, axle, set of gears.
Every MCS is equipped with photoelectric. (Transmitter and receiver)
• For using the axle-mode. The opposite MCS´s must become positioned , that the photo-
electric’s recognize itself.
• Select button paired operation (Button “E” at the operating unit) on both sides.
• For lowering of the singe axle, at you are standing: press button 2 and 4 together. The
columns towards each other will only move, when they get a signal from the opposite
column (photocell in the leg).
In case of radion connection interruption => switch SLAVES ON again, afterwords
switch MASTER ON again (see above : putting system in operation). If connection is
established again, operating the lift is possible again.
• The allowable maxi. deviation of both MCS to each other is allowed to ± 100 mm doesn't
overstep, otherwise the axis-mode is not possible.
The opposite MCS is recognized, the yellow signal lamp shines, when both buttons “Lifting
“ or both buttons “Lowering “ are pressed.