Nussbaum MCS 5500 ND WIRELESS, Руководство по эксплуатации

Страница: 28 / 57

Operating Instruction and Documentation
MCS 5500 ND WIRELESS
- 28 -
Check the colour if necessary make a repair.
Damages through outer effects are immediately to be treated after
recognising. In case of not-treatment of the positions, the powder-
coating can be durably damaged through infiltration of deposits of all
type
Grind these position (120 ryes) and after it degrease it. After it use a
suitable lacquer (Observe the RAL Number).
Check the zinc surface if necessary make a repair.
White rust becomes through lasting moisture, bad ventilation favours.
Rust is evoked by mechanical damages, wear, aggressive infiltration
(salt, water ; also in connection with other environmental influences) and
bad or not implemented cleaning.
Grind these position (A280 ryes) and after it degrease it. After it use a
suitable lacquer (Observe the RAL Number).
at least once a year
Check the hydraulic tubes for leackage. at least once a year
Check the oil level. Fill in a clean, high quality oil (32 cst)in the tank. at least once a year
The hydraulic oil has to be changed at least once a year. To change the
oil, lower the lift into the lowest position. Empty the tank and replaced
clean oil, approx. 17 litres are needed. A high quality hydraulic oil is
recommended, its should be 32 cst. (e.g.g. HLP 32 LTD. OEST
Company)
Use a ATF-Suffix hydraulic-oil (OEST Company ) if the ambient
temperature is under 5 degree centigrade. After the fill up, the hydraulic
oil must be between the upper and low marking of the oil level gauge.
at least once a year
Check all welded joints for cracks on the automotive-lift.
If any cracks are found on the lift cease use immediately. Switch-off and
secure the main switch (lock) and call the service partner
.
at least once a year
Check the condition and the function of the moving device.(pressure
spring, bolts, roller at least once a year
Check the safety device of the lift. (CE-STOP) at least once a year
Check the Battery of the controller (ASC). The Battery has a working life
at normal business between 4 ½ - 5 Years (manufacturers statement).
To avoid a permanent data-loss through an empty battery, you must
examine the battery of the controller during the regularly maintenance.
The measuring can only take place at the controller which was switched-
off. The measuring is possible with a commercial tensiometer.
standard voltage approx. 3.2 V (no exchange necessary), but a value
under 2.9 V, the
controller must be exchanged. Send the controller to the Nußbaum
Headquarter.
Before, contact your service partner.
at least once a year
Check the function of the handlever. at least once a year
Check condition and function of the moving device. at least once a year