Nussbaum MCS 5500 ND WIRELESS, Руководство по эксплуатации, Страница: 12 / 57

Operating Instruction and Documentation
MCS 5500 ND WIRELESS
- 12 -
4.Safety regulations
• Read all instructions.
• The total weight of the lifted vehicle must not exceed the maximum capacity of the lift.
• Lower the lift completely before driving the vehicle into the lifting position.
• Use the lift only as described by the instructions in this manual.
• Before lifting low clearance, sport vehicles, vehicles with ground effects or running
boards, check carefully that no damage will occur before lifting.
• Only trained personnel 18 or older are allowed to operate the lift.
• The lift operator must observe the entire lifting and lowering process.
• Only the operator may remain under the lift while in use.
• Do not lift persons on the lift or in a vehicle on the lift.
• Do not climb onto the lift when raised.
• Keep hair, loose clothing, fingers, and all body parts away from the moving parts.
• Any changes or modifications to the lift must be checked by an expert (qualified service
person).
• To reduce the risk of shock the standard lift may not be installed in a hazardous (wet)
location.
• Power supply must be disconnected (main switch, plug, breaker) before any maintenance
is performed on the lift.
• Care must be taken as burns can occur from touching hot parts.
• Do not operate equipment with a damaged cord or if the equipment has been dropped or
damaged until it has be examined by a qualified service person (expert).
• To reduce the risk of fire, do not operate equipment in the vicinity of open containers of
flammable liquids (gasoline).
• ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses only have impact lenses,
they are not safety glasses.
• Adequate ventilation should be provided when working on operating internal combustion
engines.
• Do not let a cord hang over the edge of the table, bench, or counter or come in contact
with hot manifolds or moving fan blades.
• If an extension cord is necessary, a cord with a current rating equal to or more than that
of the equipment should be used. Cords rated for less current than the equipment may
overheat. Care should be taken to arrange the cord so that it will nor be tripped over or
pulled.
• Always unplug equipment from electrical outlet when not in use. Never use the cord to
pull the plug from the outlet. Grasp plug and pull to disconnect. Let equipment cool
completely before putting away. Loop cord loosely around equipment when storing.
• Vehicles with low clearance or vehicles that are specially equipped should be pre tested
to ensure that they clear the lift ramp to avoid damage.
• The mobile column lift must be checked from an expert after changes in construction.
• It’s not allowed to start with operations at the lift before the main switch is switched off.
• During lifting or lowering the operator must observe the vehicle to ensure that the vehicle
and the lift are functioning correctly.