Nussbaum 4.65H, Инструкция по эксплуатации и документация

Страница: 30 / 45

Operating instructions and documentation
4.65H/ 4.65 plus
- 30 -
If theses repairs are not made immediately, permanent damage to the powder-coated surface may result.
Repair and clean damaged areas with an abrasive paper (grain 120). After this is complete, use a suitable
paint (observe the RAL Number).
• Check the zinc surface and repair it with a suitable tool. Use abrasive paper (grain 280).
White rust can result from moisture laying in certain areas for long periods of time. Poor aerating can also
result in rust formation.
Rust may result from mechanical damage, wear, aggressive sediments (de-icing salt, liquids) or
insufficient cleaning.
Repair and clean these areas with abrasive paper (grain 280).
After this is complete, use a suitable paint (observe the RAL Number).
• The hydraulic oil has to be changed at least once a year. To change the oil, lower the lift into its lowest
position. Empty all tanks and refill with clean oil, approx. (see chapter 3.) per hydraulic unit are needed.
Use an ATF-Suffix hydraulic-oil (OEST Company) if the ambient temperature is under 5 degrees
centigrade. After filling, the hydraulic oil must be between the upper and lower markings of the oil level
gauge.
Remove the old oil according to the appropriate regulations.
• Check the hydraulic tubes for leakage.
• It is prescribed (VBG 14, § 52-3 German regulation) to exchange the hydraulic hose if its necessary, but at
least every 6 years.
• Check that all screws and bolts are correctly torque (turning moments, see the list)
7.2 How often must the lift be cleaned?
A regular and appropriate maintenance practice will aid the preservation of the lift.
No guarantees can be given when damage (egg rust or fading colour) is the direct result of poor
maintenance and cleaning practice.
Regular cleaning of all kinds of dirt is the best protection against wear and the formation of rust and
will prolong the life of the lift
Dirty deposits that can cause rust include:
• de-icing salt
• sand, pebble stone, natural soil
• all types of industrial dust
• water; also in connection with other environmental influences
• all types of aggressive deposits
• constant humidity caused by insufficient ventilation
Obviously this is dependent on the type of work being done with the lift, the degree of cleanliness
of the workshop and location of the lift. The degree and amount of dirt is dependent on the season,
on the weather conditions and the ventilation of the workshop.