Nussbaum 4.65H, Инструкция по эксплуатации и документация

Страница: 26 / 45

Operating instructions and documentation
4.65H/ 4.65 plus
- 26 -
5.2 Lowering the vehicle with automotive
lift
• Check the dangerous places of the lift and be sure that there are no objects or people in the
immediate area of the lift or on the lift.
• Turn the key on the position ”
▼
”.
• The four safety ratchets are pulled back automatically. After 1 sec. the lowering starts.
• Lower the lift into desired position. Observe the complete process.
If the main lift is on a height of approx. 400 mm over the floor, the lift stops the
lowering (CE-Stop). Check the dangerous places of the lift and be sure that there are
no objects or people in the immediate area of the lift or on the lift. Turn the key in
position 0 and after this in position ”
∇
∇ ∇
∇
” . You hear an acoustic warn signal until the
lift is in the lowest position.
• If the lift is in the lowest position drive the vehicle off the lift.
5.3 Lowering the automotive lift in the ratchet strip (wheel alignment)
• Before the first wheel alignment, loose only the nuts (M8) from the sliding plates under the
rails.
• The sliding plates must be locked when using the automotive lift.
• Position the vehicle on the lift.
• Unlock the sliding plates.
• Position the turn tables under the wheel. If necessary use the Jack.
• Check the dangerous places of the lift and be sure that there are no objects or people in the
immediate area of the lift or on the lift.
• Press the button “lowering in the ratchet” at the key switch. (see pic.1)
• Press the button so long until all four ratchets are locked.
5.4 Raise the automotive lift out of the ratchet strip
• Check the dangerous places of the lift and be sure that there are no objects or people in the
immediate area of the lift or on the lift.
• Turn the key on the position ”
∆
” until the ratchets are free.
5.5 Lifting the vehicle with wheel free jack
• Drive vehicle onto automotive lift, position centered.
The vehicle needs to stand completely on the drive-on rail to prevent it from falling off.
For short vehicles flap off ramps and/ or slide support arms so that the wheels can
move freely.
For extra long vehicles pull out the support arms to extend the drive-on rails by the
ramps.
• Protect vehicle against rolling: engage the gear, put hand brake.
• Check the dangerous places of the lift and be sure that there are no objects or people in the
immediate area of the lift or on the lift.
• Position polymeric overlay underneath the application points required by the vehicle
manufacturer.