NTT docomo FOMA N706i, Инструкция по эксплуатации

Страница: 55 / 519

53 Continued on next page
V
o
ice/Videophone Ca
lls
z
If the videophone call is not connected, your call is
automatically switched to a voice call when you set
“Auto redial as voice” to “ON”. However, the call
may not be handled in this way if you call an ISDN
synchronous 64K, ISDN videophone which does
not support the 3G-324M standard (as of June,
2008) or if you dial a wrong number. Note that call
charge may be applied in some cases.
Switching a Voice/
Videophone Call during a Call
(Caller)
z
You can use this function with the terminals
compatible with voice call/videophone call switch.
z
You can switch the voice call only when you are the
caller.
z
To switch the call, the receiver needs to set “Ntfy
switch-mode” to notify the switch beforehand.
→ P.72
<Example: To switch a voice call to a videophone
call>
1 In-call screen (P.50)
d
(V. phone)
“YES”
While switching, the screen which indicates that
the calls are being switched appears and the
voice guidance is played.
■
To switch a videophone call to a voice call
Videophone in-call screen (P.50)
u
(FUNC)
“Change to voice”
Out of service area/
power off The other party is out of service
area or the phone is turned off
Your call is being
forwarded The call is being forwarded (A
Videophone call is made when
the forwarding number is for a
3G-324M-compatible
videophone)
Redial using voice
call The phone for the forwarding
number is not compatible with
videophone calls
Please activate
caller ID before
dialing again The other party sets the Caller
ID request service
This number is not
available The other party sets the
Nuisance call blocking service
Upper limit has been
exceeded
Connection failed The upper limit set for a Limit
billing plan (Type Limit and
Family Wide Limit) is exceeded
Connection failed Set the caller ID notification to
“ON” and retry
You connected without notifying
your caller ID (when dialing into
visualnet, etc.)
• This message may also
appear in other situations
Please make your
call from the i-mode
web page You attempted to make a
videophone call to watch V-live
without browsing the i-mode
official site
Display Cause
N
z
It takes about 5 seconds to switch the calls. Note that
the signal quality may affect how long it takes.
z
You cannot switch the calls during calling in the
following cases:
• When the other party is holding the call
• When the other party activates Record message
z
The displayed call duration is reset to 0 second each
time the calls are switched. However, the total time for
voice and videophone call is displayed after ending a
call.
z
Depending on the other party’s communication
conditions or the signal quality, you may not be able to
switch the calls and the call may be canceled.
z
When the call is switched, the first dialed or received
call is registered to the Redial/Dialed calls records or
Received calls records.
<When switching from voice call to videophone call>
z
If the caller is using i-mode, the i-mode
communication is canceled to switch to videophone.
z
If the other party is using packet communication
(including i-mode), you receive the message “No
Switch” meaning you cannot switch the calls.
The digital
communication fee
is charged after
the appearance of
this screen.