NTT docomo FOMA N706i, Инструкция по эксплуатации

Страница: 501 / 519

48
AT Command List
AT commands available on FOMA terminal
d
The following abbreviations are used in the AT command list;
[&F] : Command of which setting is initialized by AT&F command.
[&W] : Command of which setting is saved by AT&W command. The setting can be retrieved by
ATZ command.
d
When you make a call via an external device or using AT command, the call is made from Number
A in A mode/Dual mode, and from Number B in B mode.
Modem port command list
The followings are the usable commands for "FOMA N706i Ⅱ ( モデム )" (modem):
AT command Outline Parameter/description Command execution example
A/ Executes the last executed
command again. No carriage
return is necessary.
−
A/
OK
AT
−
The modem function of a FOMA terminal is
controllable by adding the command of this
table after this command. On this list, this
command (AT) is displayed with another
command from the list attached to it.
* OK is answered even when only AT is entered. AT
OK
AT%V Displays the version of the
FOMA terminal.
−
AT%V
Ver1.00
OK
AT&C n
[&F] [&W]
Selects the operating
condition of the circuit CD
signal to DTE.
n
= 0
：
CD is always ON.
n = 1 ： CD changes according to the carrier of
the other party's modem (initial value).
AT&C1
OK
AT&D
n
[&F] [&W]
Selects the operation to
take place when the circuit
ER signal received from
DTE transits between ON
and OFF. n
= 0 ： Ignores ER status (always assumed
to be ON).
n
= 1 ： When ER changes from ON to OFF, it
becomes an on-line command status.
n
= 2 ： If ER changes from ON to OFF, a
connection is disconnected and it will be in
an off-line command status (initial value).
AT&D1
OK
AT&E n
[&F] [&W]
Selects how to display the
connection speed.
n = 0 ： Displays the wireless network
transmission speed.
n = 1 ： Displays the DTE serial
transmission speed (initial value).
AT&E0
OK
AT&F
n
Restores all of registers to
their defaults. If this
command is input during
communication, the line will
be disconnected. Only
n
= 0 can be specified (can be omitted). (At the time of off-line
mode)
AT&F
OK
AT&F?
ERROR
AT&F
＝ ?
ERROR
(At the time of on-line
command mode)
AT&F
NO CARRIER
(Change to off-line
mode)
AT&S
n
[&F] [&W]
Sets the Data Set Ready
signal to be output to DTE. n
= 0
：
DR is always ON (initial value).
n
= 1
：
DR signal is ON when the line is
connected (when the
communication call is established).
AT&S0
OK