NR Electric RCS-9698G, Инструкция по эксплуатации

Страница: 55 / 81

Chapter 4 HMI Operation Introduction
NR ELECTRIC CO., LTD. 45
the correct password and press key into parameter edit pattern. Once want to quit from the
parameter edit pattern without any modifications on parameters, press key. Use any of
Cursor control keys to select the desired item and keys to make expected
parameter settings, finally, press key to validate the modifications.
4.5.3.1 NET SET
This submenu is used for configuration of network parameters. It is displayed as below:
Figure 4.5-18 Data Display
There are four groups of Ethernet parameters corresponding to four Ethernet Ports. Each group of
the net parameters contains contralateral network segment, gateway and subnet mask described
as in the following table.
Table 4.5-1 NET SET
Items Description Default Setting
CPU n -IP m The IP address of the relevant Ethernet port 198.120.000.199
CPU n -IP m -MASK
The subnet mask of the relevant Ethernet
port
255.255.000.000
CPU n -IP m -ROUTER1
The first gateway of the relevant Ethernet
port
000.000.000.000
CPU n -IP m -OUT1
The first contralateral network segment of the
relevant Ethernet port
000.000.000.000
CPU n -IP m -ROUTER2
The second gateway of the relevant Ethernet
port
000.000.000.000
CPU n -IP m -OUT2
The second contralateral network segment of
the relevant Ethernet port
000.000.000.000
CPU n -IP m -ROUTER 3
The third gateway of the relevant Ethernet
port
000.000.000.000
CPU n -IP m -OUT3
The third contralateral network segment of
the relevant Ethernet port
000.000.000.000
Where n is the CPU board number and m is the Ethernet port number. Here, n and m may be
equal to 1, 2, 3 or 4.