NR Electric RCS-9698G, Инструкция по эксплуатации

Страница: 75 / 81

Chapter 6 Commissioning
NR ELECTRIC CO., LTD. 65
Table 6.3-1 Power supply range of RCS-9698G/H
Rated Voltage
3 options to be selected:
110V/125V DC;
220V/250V DC;
48V DC
Variation (80% ~ 120%)Un
It should be noted that the device can withstand an AC ripple of up to 15% of the upper rated
voltage on the DC auxiliary supply.
WARNING:
Energize the device only if the auxiliary supply is within the specified
operating ranges.
6.3.2 With the Device Energized
The following groups of checks verify that the hardware and software is functioning correctly and
should be carried out with the power supply applied to the device.
6.3.2.1 Testing the
“
STANDBY”LED Indicators
After RCS-9698G/H is energized and finishes starting up,
the green “ STANDBY ” LED on the MASTER MACHINE will be lit off,
the green “ STANDBY ” LED on the STANDBY MACHINE will be lit on.
6.3.2.2 Testing the LED Indicators of CPU/COM/MDM board
If a CPU/COM/MDM board operates normally, the corresponding green “ HEALTHY ” LED will be lit
on and the corresponding green “ ALARM ” LED will be lit off.
If any error is detected in a CPU/COM/MDM board during operation, the corresponding green
“ HEALTHY ” LED will be lit off and the corresponding red “ ALARM ” LED will be lit on.
If any IED is linked to an RS-232/422/485 serial port, an ethernet or a MOMEM port of
RCS-9698G/H , the corresponding “ ACT ” LED will be lit on.
If some data are transmitted and received via a port, the corresponding “ ACT ” LED will flash.
6.3.3 Communication Function Testing
RCS-9698G/H should be used together with the RCS-9798 Configuration Tool , the RCS-9798
Debugging Tool and the control center simulation tools for communication function testing.
6.3.4 Final Check
After the above tests are completed, remove all test or temporary shorting leads, etc. If it has been
necessary to disconnect any of the external wiring from the device in order to perform the wiring
verification tests, it should be ensured that all connections are replaced in accordance with the
relevant external connection or scheme diagram.