NPK SCS-1002, Руководство по эксплуатации

Страница: 25 / 80

25 Version 0.2
SCS-1002 Hospital and refrigerator alarm system
All SCs start operation automatically once the power is supplied.
To power the SCs, firstly, turn on a circuit breaker on the main switchboard, then,
transfer a power button to ON position – on SCS-SPS, or press Power button – on
SCS-CU, if it is not active.
At least 30 sec after switching on, the System will automatically transfer to wait
mode.
3.2.4 System settings
To provide the System settings, act as follows:
a) power up the SCs;
b) follow the steps below to set up RCD (except SCS-WP):
–
set up or reset a password (except SCS-SPS);
– set up a reset timer (20 to 80 sec);
– set up a quantity of controlled calling stations;
– set up a name and background type of the station;
– set up a timer of postponed sound signaling;
– set up an operation mode of reset button (reset or mute);
c) provide settings of SCS-WP – set up an operation mode of reset button (reset
or mute);
d) provide settings of controllers – set up a network address using DIP-switches,
see table 13.
Table 13 – Network addresses of controllers
Address
DIP-switch SW2
DIP:5 DIP:4 DIP:3 DIP:2 DIP:1
0 0 0 0 0 0
1 0 0 0 0 1
2 0 0 0 1 0
3 0 0 0 1 1
4 0 0 1 0 0
5 0 0 1 0 1
6 0 0 1 1 0
7 0 0 1 1 1
8 0 1 0 0 0
9 0 1 0 0 1
10 0 1 0 1 0