NVR
-
4532
-
H4/F User
’
s manual (short) ver.1.0
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
22
NVR OPERATING
No.
-
number of the disk.
*
means recording.
Serial No., Model, Firmware
-
disk information.
Edit
-
allow to change the HDD mode. HDD modes:
Read/Write
,
Redundance
,
Read Only
.
Type
-
information about HDD mode, which can be changed in Edit field. Default mode is Read/Write.
Disk group
-
information about HDD group, which can be changed in Edit field.
State
-
information about HDDs filling.
Free / Total
-
information about free and total HDD space.
Free / Total Time
-
estimated time of recording, which should be recorded on the free hard disk space
and the total recording time. The time depends on the encoding and the amount of video frames.
Overwrite
-
the default
Auto
setting cause recordings overwriting from the oldest when there is no
free space on HDDs. When overwriting is
OFF
, the NVR will stop recording when the disc is full. It is
also possible to set the time after which recordings will be overwritten:
1
day
,
3 days
,
7 days
,
14 days
,
30 days
,
60 days
and
90 days
. It means the longest time of stored recordings, after which the
recordings will be deleted.
Format HDD
-
formatting the hard disk. Select the HDD before it.
Caution! You need to format the disc to start recording. Formatting deletes all data permanently
from the hard disk.
3.3.5. Monitor output resolution
The next section allows to select the monitor output resolution. Following HDMI output resolutions are
supported: 1024x768, 1280x1024, 1440x900, 1280x720, 1920x1080, 1600x1200, 1920x1200,
2560x1440, 3840x2160. VGA output supports resolutions up to 1920x1080.