Novexx Solutions XLP 604, Руководство пользователя

Страница: 43 / 124

User Manual XLP 604
Options Options (continued) Options (continued)
Selection ├ Multilabel mode Start Sensor
├ Periph.device ├ Label2 offset
[8]
├ Startprintmode
├ Statussignals └ Label3 offset
[9]
├ Starterrorstop
├ Applicator
[10]
├ Dispenseposition └ Externalsignal
├ Applicator type ├ Dispensingedge
Rewinder
[11]
└ Extension signals ├ Applymode ├ Rewinddirection
└ USI Signals
[10]
├ Head disp dist.
[12]
├ RewinderValues
Dispenser
[13]
├ Displaymode └ Rewinderadjust
├ DispenseMode ├ Dispensecounter
Tear-off edge
[14]
├ Real 1:1 └ Disp.Cnt.Reset └ Dispenseposition
├ Dispensingmode
Cutter
[15]
LTMA
[16]
└ Max InitFeedback ├ Cut mode ├ ApplyMode
├ Speed ├ Cut speed ├ Strokelength
├ Printspeed ├ Cut width ├ Appl.Waitpos.
└ Feedspeed ├ Cut position ├ Applicatorspeed
├ Start Signal ├ Doublecut └ Restartdelay
├ Startoffset └ Rest position
USI
[17]
├ Startprintmode Material OD Sensor ├ Reprintsignal
├ Applicationmode ├ Mat.ODSensor1 ├ Feedinput
├ Start source ├ Mat.ODSensor2 ├ Pauseinput
├ Starterrorstop ├ Materialenderr
[18]
└ Cycle mode
├ Productlength ├ Materialendwarn
[18]
Keyboard
└ Ext.ODsensor
[19]
Table 10: Parameter menu part 2 (parameters in brackets are only visible with “service mode” access rights)
8
Only with Dispenser > Start Signal > Multi label mode = “x labels/start”
9
Only with Dispenser > Start Signal > Multi label mode = “x labels/start” with x=3
10
Only with 8IO board installed
11
Only with Options > Selection > Periph. device = “Rewinder”
12
Only with Dispenser > Dispensing edge = “User defined”
13
Only with Options > Selection > Periph. device = “Spender”
14 Only with Options > Selection > Periph. device = “Tear-off edge”
15
Only with Options > Selection > Periph. device = “Cutter”
16
Only with Options > Selection > Periph. device = “LTMA”
17
Only with Basic-USI or BasicIO board installed
18
Only with Options > Material OD Sensor > Mat. OD Sensor 1 = “Rotation pulse” or Options > Material OD Sensor > Mat. OD Sensor
2 = “Rotation pulse”
19
Only with Options > Material OD Sensor > Mat. OD Sensor 1 = “Level high activ” or “Level low active”
or
Options > Material OD
Sensor > Mat. OD Sensor 2 = “Level high activ” or “Level low active”
Edition 2 - 12/2021 43 Product Description
Parameter menu