NWDC
IM 26 MAR 2014 © 2014 Novatec, Inc. All Rights Reserved
Page 7
[Type text]
[Type text]
NWDC IM 26 MAR 2014
2
Assembly Instructions
Basic Components of NOVATEC NWDC Dryer Assembly
1.2.1 Prepare/Assemble Machine Mount Receiver
NOTE: As you proceed with assembly, make sure that all bolts and hose
clamps are securely fastened to ensure that there are no air or material
leaks in the system. Do not use excessive flex hose but avoid sharp turns
as this will hurt the efficiency of the system operation.
1-B
1-C
1-A
: If Machine Mount Receiver base has not been pre-drilled,
remove base from Machine Mount Receiver and drill holes
to match machine throat hole pattern and re-attach base to
MM Receiver.
1-B
: Attach Photo Eye Level Sensor to the bracket provided.
1-C
: Connect 115/1/50-60 VAC wiring to twist lock plug.
(supplied)
1-A
Vacuum
Purge Valve
Identifying Major Components:
Vacuum
Purge Valve
Vacuum
Purge Valve
Receiver
Mounting Plate
Hopper
Receiver
VR-5 or VR-12
NWDC Dryer
Photo Eye Level
Sensor
Machine Mount
Receiver
Electrical
Enclosure
EPV Dual Station
Vacuum Valve
Stubs
Pickup Wand
Material
Hopper
Control
Panel
Dryer/Hopper
Assembly
Flex Hose
5” Casters
Pre-mounted on all EXCEPT-150
Install first on -150
Tools You Will Need for Assembly:
Hacksaw to cut PVC flex hose
Flat Blade Screwdriver and/or 5/16” socket for hose
clamps
5/32” Allen wrench to mount Receivers
Drill press and drill bit sized to match mounting holes
on machine throat so holes can be drilled in base of
Machine Mount Receiver. (Unless base is pre-drilled)
6’-8’ Ladder
Tape measure
