NWDC
IM 26 MAR 2014 © 2014 Novatec, Inc. All Rights Reserved
Page 35
[Type text]
[Type text]
NWDC IM 26 MAR 2014
11.5 Motor Rotation Signal
Check that the wheel rotor is rotating properly and each time a signal goes to the controller,
ensure that rotor complete its cycle and the limit switch hump has reset the limit switch
provided near the rotor. If the hump is not resetting the limit switch, reset the limit switch
toward the rotor.
11.6 Rotor Replacement
Desiccant rotor removal is accomplished bas follows:
1.
Remove the hex nuts on the Top Plate Assy..
2.
Remove the washers & spring from the Tie Rod.
3.
Slide the Top Plate Assembly straight & upward gently.
4.
Loosen the Supporting Tie Rod from where rotor is to be moved.
5.
Remove the driven sprocket.
6.
Slide the Rotor straight & upward, make sure that rotor does not get damaged.
7.
Replace the desiccant rotor.
To re-install rotor, reverse the above procedure.
