Norton Clipper CB 511, Руководство по эксплуатации

Страница: 22 / 36

VERS.2017.11.21 CB511_CB 651_MAN_EN
22
5.3.2 Starting and stopping the machine
Properly plug in the EEC Standard electric plug. The switch is located in a comfortable position,
accessible from the operator’s workplace. The switch is an overload cutout type with circuit breaker
and power failure release coil.
After making all preliminary checks insert the plug into the outlet on the machine.
Press the switch’s green START push-button to start blade motion. Press the switch red STOP
push-button to stop the machine (Pic.6). Check that the direction of rotation is correct and that the
blade teeth face downwards (Pic. 7).
CAUTION: Before starting the machine make sure that the blade is well taut, using the
guidelines affixed on the machine.
IMPORTANT:
Do not be distracted when working, keep your hands away from the
cutting area. When cutting small pieces use special pushers with handles: make these
yourself depending on the job being done.
CAUTION: The lowering blade guard must be correctly adjusted and clamped 5 mm
above the piece to be cut (Pic. 8) before starting to work.
It is absolutely necessary that all work procedures be performed by a single operator
and not by several persons.