Norton Clipper CB 511, Руководство по эксплуатации

Страница: 32 / 36

VERS.2017.11.21 CB511_CB 651_MAN_EN
32
8
– FAULTS : CAUSES AND CURES
8.1 Fault-finding procedures
Should any fault occur during the use of the machine, turn it off, and isolate it from the electrical
supply. Any works dealing with the electrical system or supply of the machine can only be carried
out by a qualified electrician.
8.2 Trouble-shooting guide
Panne Source possible Résolution
Motor is not running No electricity Check the electrical supply (fuse
for example)
Connection cable
section too small Change connection cable
Defective connection
cable Change connection cable
Defective switch CAUTION : can only be solved by
a qualified electrician
Defective motor Change motor or contact motor
manufacturer
Motor stops during the cutting, but can
be restarted after a short period Cutting advance too
quick Cut slowly
Defective blade Change blade
8.3 Warranty
Warranty coverage is excluded on parts which are due to natural wear, thermal stresses, weather or
breakdowns caused by incorrect connections, installation, operation or lubrication or caused by
forceful interventions. Warranty coverage is excluded on electrical and electronic apparatus in case
of damages caused by inappropriate voltage (insufficient or excess voltages).
In addition no warranty coverage shall be recognized for damages caused by improper use or
misuse of the machine such as unsuitable modifications or repairs made by the owner or by third
parties under their own responsibility and also in case of intentional overloads of the machine.
Parts subject to wear (for example cutting blades, drive belts or drive chains, blade guides,
bearings, thrust bearings, condenser) as well as performance of all adjustment and calibration
works are totally excluded from the warranty.