Norton Clipper CB 511, Руководство по эксплуатации

Страница: 28 / 36

VERS.2017.11.21 CB511_CB 651_MAN_EN
28
6 -
MAINTENANCE
CAUTION ! All adjustment and maintenance procedures must be done with the machine
stopped, the motor off and the power supply cut off! It is prohibited to tamper with or
remove guards.
Pay attention to your hands: rotating blade !
It is prohibited to remove residual materials and dust while the blade is moving.
It is prohibited to clean the blade while it is moving.
During maintenance: use sturdy gloves to handle the blade. Be careful of the spring effect. Always
post a sign to indicate when a machine is out of use due to operating problems.
DO NOT WASH THE MACHINE WITH WATER
Use a vacuum-cleaner or a small compressor to clean the machine.
Do not grease: use only atomized oil in spray can.
6.1 Blade adjustment and replacement
These procedures must be performed with the power plug disconnected.
No guard needs to be dismantled to install the blade. To remove the
blade open the hatchways, lower guard (1 Pic.12) down to the level of
the table and turn it to the right. Unscrew and remove the knob (1 Pic.13)
and rotate the handle (2 Pic. 13). Then install the blade and make sure it
is housed properly in the blade guides (Pic. 14). The blade must be well
taut by the handwheel (1 Pic.15) until the tip of the arrow (2 Pic. 15) lines
up with the green colored notch (3 Pic.15).