Norton Clipper CB 511, Руководство по эксплуатации

Страница: 24 / 36

VERS.2017.11.21 CB511_CB 651_MAN_EN
24
5.4 Sequences for cutting GASBETON
START UP – CUTTING PHASE
Pressing the green push-button starts the blade moving. The
blade stops by itself at the end of the table’s travel.
The green push-button must be reset after each cut.
WARNINGS FOR INTERMEDIATE CUTS
The blade does not stop by itself when an intermediate cut is
made on a piece.
The operator must use the stop push-button to
first stop the blade and then remove the pieces.
TABLE FORWARD FEED
Important: always make cuts with moderation.
(give the blade enough time to work).
WARNINGS WHEN MAKING VERTICAL CUTS ON BLOCKS
Make sure the piece is stable and resting on a good support
surface. Proceed with very moderate forward speeds. Avoid
making vertical cuts on pieces with insufficient support surface.
This procedure must be performed by a capable
and experienced machine operator.
MOTOR
Turn the motor off immediately if the blade seizes. (red button)
WARNINGS
Absolutely avoid putting your hands in the cutting area when the blade is moving!
Do not operate the machine when breakdowns or defects occur: wait until they
have been removed.
When cutting use low thrust pressures
and “slow” even forward feed speeds make
sure the blade is stopped when handling the block before and after the cutting
phase.
Absolutely do not put your hands in the cutting area when the blade is moving.