Northern Tool and Equipment Powerhorse 63388, Руководство пользователя

Страница: 15 / 31

Page 15 of 31
DO NOT attempt to start this machine until all assembly has been completed. Serious personal injury
and damage to the machine could occur.
Install Stand (See Figure 1)
1. Position the stand (A) underneath the engine base.
2. Using the four M8x60 bolts (C) and four nuts (D), tighten the stand with the engine base plate.
Install the Wheels (See Figure 2)
1. Place the wheel onto the axle (B). Make sure the wheel disc flat side faces the machine.
2. Slide the washer (A) onto the axle against the wheel.
3. Insert the cotter pin (C) into the hole to secure the wheel on the axle.