Northern Tool and Equipment Powerhorse 63388, Руководство пользователя

Страница: 21 / 31

Page 21 of 31
engine cooling fins.
We recommend having this service performed by an authorized dealer.
Inspect / Rotate Shredding Hammers (See Figure 7)
Service Interval: Every 25 Hours, or As Necessary
The shredding hammers of this unit can be rotated to provide a new cutting surface as required. The
Y hammers can be flipped over once. To inspect the shredding hammers:
1. Disconnect the spark plug wire and secure it away from the spark plug.
2. Remove the small circular access panel (B) from the back of the shredder housing.
See Figure 7.
3. Inspect the cutting edges of the Y-hammers (A).
TRANSPORTING AND STORAGE
1. Always observe safe refueling and fuel handling practices when refueling the unit after
transportation or storage.
2. Never store the unit (with fuel) in an enclosed poorly ventilated structure. Fuel vapors can travel to
an ignition source (such as a furnace, water heater, etc.) and cause an explosion. Fuel vapor is also
toxic to humans and animals.
3. Always use the hopper handle and built-in wheels to move the wood chipper. Never lift the unit
using the fuel tank for support. If the unit must be lifted, always use at least two people, and always
grip the unit securely using the front leg and hopper handle.
4. Always follow the engine manual instructions for storage preparations before storing the unit for
both short and long term periods.
5. Always follow the engine manual instructions for proper start-up procedures when returning the unit
to service.
6. Never store the unit or fuel container inside where there is an open flame or pilot light, such as in a
water heater. Allow unit to cool before storing.
Storage