Nortel TDM Recorder, Руководство по установке

Страница: 71 / 128

September 2007 Setting up the System
Installation Guide 71
Configuring adapter cards
Configure your CTI adapter card(s) to ensure that Nortel TDM Recorder
communicates properly with the switch. You configure each adapter card
using the Recorder Manager to assign channels to be recorded.
To configure each CTI adapter card:
Configure each card to attach a switch type and recording method for
recording calls.
1 In the Recorder Manager click General Setup > Voice Cards .
Note: All Voice cards that are installed are detected and listed, with
exclamation marks indicating newly detected cards.
2 Click a card to highlight it, then set all appropriate fields, including Switch
type, E1/T1, Framing, Line Coding, and any other known parameters
according to the following:
Record Method
Tap Sense
Mode
Card Setting Channel Setting
CTI/UNIFY Driven
Only, No Recording
without Unify when
in Fallback Mode N/A Vox Enabled =
This Setting Is
Not Used Start on Tap = Never
Stop on Tap = Never
CTI/Unify During
Normal Operation,
Tap Sense During
Fallback Mode VOX, audio
voice energy only Vox Enabled =
Checked Start on Tap = FallBack
Stop on Tap = FallBack
ISDN D-
Channel, Robbed
Bit CAS bits,
Digital Extension
Tap Events or
Line Voltage Vox Enabled =
Unchecked