Nortel TDM Recorder, Руководство по установке

Страница: 113 / 128

September 2007 Voice Card Configurations
Installation Guide 113
Vox Enabled Options are Yes and No. Default is No. Required
updateable field.
This setting specifies whether the Recorder uses VOX
detection or D-channel decoding as the type of tap
information to use for the
Start on Tap and Stop on Tap
settings. The options are Yes for VOX detection or No for
D-channel decoding. The default setting is No for D-
channel decoding.
When the TDM recorder is being used as a TDM slave in a
Nortel Contact Recording environment, and if you are using
VOX fallback, then the Vox Enabled setting should be set
to Yes, and both the Start on Tap and Stop on Tap settings
should be set to
In Fall Back . With these settings,
recording takes place in VOX fallback mode using VOX
detection information if the CTI server fails.
If you plan to use VOX detection, ensure that you test and
set the VOX detection levels on each channel.
If you want to use D-channel decoding as the recording
fallback mechanism, then the VOX Enabled setting should
be No.
PBX Type Type of PBX device that the recorder is interfacing with;
alphanumeric entry. Optional
Max Record
Time Maximum record time for a single call segment. Default is
3600 seconds. This field is editable and required
Fall Back
Time Maximum elapsed time in seconds before the recorder
switches to "tap sense" mode if there is a loss of CTI feed.
Default is 30 seconds. This field is editable and required
Field Description