Nortel TDM Recorder, Руководство по установке

Страница: 29 / 128

September 2007 Recorder Hardware Installation
Installation Guide 29
Using Bridge Clips
With Bridge Clips, the second leg of the punch-down block receives a
duplicate PBX signal from the first leg. The NGX is then connected to the
second leg of the punch-down block. Although it is not as flexible as the
Y-Splitter, this method is a viable means of passively tapping a PBX at the
punch-down block with the NGX. Bridge Clips are applied between the first
leg of the punch-down block to the second leg to duplicate the PBX signal
between the legs.
Using Bridge Clips limits you to wiring only one leg of the punch-down
block to the phones while the second leg must be dedicated entirely to the
NGX. Use this method only if the Y-Splitter method is not possible.
PBX
Punch-down block
NGX Wiring with Bridge Clips Scenario
Phones
DETAIL
Bridge clips
couple 1st leg
of punch-down
block to 2nd leg
LEGEND:
Standard Twisted
Pair Cable
50-Pin Centronics
ML Cable
RJ-21 X Connector
NGX Voice Card
Bridge Clip