General switch administration using the Command Line Interface
175
The syntax for the
no ip address unit
command is
no ip address unit <1-8>
Run the
no ip address unit
command in Global Configuration
command mode.
"no ip address parameters" (page 175)
describes the parameters this
command.
no ip address parameters
Parameters and
variables
Description
unit <1—8>
Zeroes out the IP address for the specified unit.
Note: When you change the IP address or subnet mask, connectivity to
Telnet and the Internet can be lost.
default ip address command
The
default ip address
command sets the IP address for the specified
unit in a stack to all zeros (0).
The syntax for the
default ip address
command is
default ip address
Run the
default ip address
command in Global Configuration
command mode.
Note: When the IP gateway changes, connectivity to Telnet and the
Internet can be lost.
Displaying Interfaces
You can view the status of all interfaces on the switch or stackd, including
MultiLink Trunk membership, link status, autonegotiation, and speed.
show interfaces command
The
show interfaces
command displays the current configuration and
status of all interfaces.
The syntax for the
show interfaces
command is
show interfaces [names] [<portlist>] [gbic-info]
Run the
show interfaces
command in User EXEC command mode.
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
