202
Switch administration tasks
Section
Item
Range
Description
remote management if no BootP
server is set up for the switch, but it
enables the switch to boot normally.
BootP Disabled
Choose this mode to inform the
switch, each time the switch
boots, to use the IP configuration
parameters stored in non volatile
memory. If a BootP configuration
is in progress when you issue this
command, the BootP configuration
stops.
BootP or Last Address
Choose this mode to inform the
switch, at each startup, to obtain its
IP configuration using BootP. If the
BootP request fails, the switch uses
the network parameters stored in its
non volatile memory.
Note: Valid parameters obtained in
using BootP always replace current
information stored in the non volatile
memory.
Boot Mode
Setting
(continued)
Note: Whenever the switch broadcasts BootP requests, the BootP
process times out if a reply is not received within (approximately)
7 minutes. When the process times out, the BootP request mode
automatically changes to BootP Disabled mode. To restart the
BootP process, change the BootP request mode to one of the three
following modes: BootP When Needed, BootP Always, or to BootP or
Last Address.
In-Band
Stack IP
Address
XXX.XXX.XXX.XXX
Type a new stack IP address in the
appropriate format.
In-Band
Switch IP
Address
XXX.XXX.XXX.XXX
Type a new switch IP address in the
appropriate format.
Note: When you enter the IP address
in the In-Band IP Address field, and
the In-Band Subnet Mask field value
is not present, the software provides
an in-use default value for the In-Band
Subnet Mask field that is based on
the class of the IP address entered in
the In-Band IP Address field.
IP Setting
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
