Figure 8. Bracket Location
Figure 9. Installation of Heater Elements
Figure 11. Securement Screw Locations (×3)
Figure 12. Wire Passage Foam Grommets
Figure 10. Element Support Bracket
Screw
Screw
Screw
Figure 7. Element Line Voltage Connections
to circuit breaker L1, L2, and L3 as shown in
or attach
directly to 3 pole terminal block L1, L2, and L3 if no
breaker is used.
9. Carefully slide electric heat kit into place by aligning the
formed “J” hooks at the top of the element mounting plate
to the element mounting bracket located under the blower
mounting deck. See
and
.
10. Secure the element assembly by aligning the two
clearance holes in the bottom flange of the element
mounting plate to the bottom pan and then one in the
rear of the element assembly support bracket as shown
in
and
.
11. Route all wiring out the two wire passage holes and foam
wire guards. See
.
NOTE: Power wires can exit through
either opening but control wiring should exit the top.
12. Attach the high voltage Black (L1), Yellow (L2), and Red
(L3) element wires to T1, T2, and T3 on the 3 pole control
contactor.
13. Connect and securely lock the low voltage 3 pin plug
from the electric element assembly to the mating plug
from the 3 pole contactor.
14. Connect and securely lock the low voltage 6 pin plug
from the electric element assembly to the mating plug
from the main unit control panel.
15. Replace the electric heat access plate using screws
removed in Step 3.
NOTE: Make sure the wires are not
5
CP-H9HK (05-20) 1012566-B
