Nordson PowderPilot HD, Руководство пользователя

Страница: 18 / 52

Powder Pilot ™ HD
P/No.7192721_02
Page | 18
7 – reset production data – this button will reset the shift counters mentioned above
To reset the shift counters, touch the counters and the button will appear Pressing this button will reset
them and the button will then automatically disappear again
8 – gun fault status – This button will display the gun fault screen where a more detailed fault code
can be obtained for any gun
Exit screen Reset errors
1 2
1 – KV node errors for Gun 5 – fault occurred on KV side of gun number 5
2 – Pump node errors for Gun 5 – fault occurred on KV side of gun number 5
If any of these “LED - symbols” is drawn as red light, try to reset the fault by touching the reset button in
the top right corner of the screen
If the problem persists, contact your Nordson representative for information on these codes
The fault codes indicated are explained as follows-
KV card faults- Pump card faults-
E1 uA has not reached alarm set point. This is used with Tribo
guns where a low charge uA value is set for alarm F1 Communication. The pump card has lost
communication with the gateway
E2 Fold back. The gun is trying to draw more than 100uA F2 No 24V. The 24V supply to the pump system
has been lost
E3 Feedback. The uA feedback wire is broken in the gun
cable F3 General alarm. On for any other fault that
cannot be detailed in this list
E4 Open circuit. The voltage multiplier is open circuit F4 Reserved for future use.
E5 Short circuit. The voltage multiplier is short circuit F5 Powder air is higher than set point
E6 Hardware. The KV card itself has a fault F6 Pattern air is higher than set point
E7 General alarm. On for any other fault that cannot be
detailed in this list F7 Powder air is lower than set point
E8 No 24V. The 24V supply to the KV system has been lost F8 Pattern air is lower than set point