Nordson PowderPilot HD, Руководство пользователя

Страница: 36 / 52

Powder Pilot ™ HD
P/No.7192721_02
Page | 36
Spectrum HD MANUAL CONTROL SECTION
Pushing the button on the Spectrum HD control screen will display controls for manual
operation of various devices of the feed centre.
Note: the operator takes full responsibility of his actions on the system.
All automatic functions of the Spectrum HD are inactive while on that screen.
Exit screen
1 2 3 4 5 6 7 8 9
1
– Dump valve – This button is used to open / close the dump valve in the bottom of the hopper.
2 – Virgin HDLV transfer pump on/off – This button is used to start or stop the virgin pump.
3 – Main duct damper – used to open or close the damper inside the main extraction duct behind the
feed centre.
Note: when this duct is closed, the full extraction goes to the purge duct on top of the sieve.
4 – Recycle HDLV transfer pump on/off – This button is used to start or stop the reclaim pump located
at the cyclone or a custom recycling system.
5 – Vibrator motor on / off – this button starts or stops the vibratory motor installed into the virgin powder
box support.
6 – Purge duct damper – used to open or close the damper inside the purge duct on top of the sieve.
7 – ultra-sonic sieve on/off – this button starts or stops the ultra-sonic sieve.
8 – main air solenoid – this button opens or closes the main air solenoid in the supply line to the feed
centre.
9 – Hopper fluidisation on / off – this button starts or stops fluidising the powder inside the hopper