Nordson kinetix, Руководство пользователя

Страница: 49 / 76

Repair
7-9
Part 334598G03
E
2008 Nordson Corporation
Ball Tip and Packing Cartridge Installation
See Figure 7-6.
NOTE: Make sure all residual coating material has been removed from all
parts before installing.
1. Apply a removable threadlocking adhesive to the threads of the packing
cartridge puller fitting (B).
2. Screw the pull shaft (20) onto the packing cartridge (18).
3. Apply a liberal amount of dielectric grease to the puller fitting and the
pull shaft then insert the packing cartridge assembly and pull shaft into
the extension from the back.
4. Apply a liberal amount of dielectric grease to the outside of the sleeve
retainer (22) then slide the sleeve retainer over the pull shaft and push it
down into the fluid bore.
5. Generously lubricate the end of the pull shaft and the inside of the
packing cartridge retainer (23) with MagnaLube G or an equivalent
PTFE-based lubricant.
6. Apply a thin coating of dielectric grease to the threads of the packing
cartridge retainer then screw the packing cartridge retainer into the
extension.
7. Push the pull shaft forward and tighten the packing cartridge retainer
with the combination tool hand-tight.
8. Wipe off excess dielectric grease.
9. Apply a removable threadlocking adhesive to the threads of the pull
shaft and screw the puller onto the pull shaft.
Spray Gun Assembly
See Figure 7-5.
1. Make sure that the multiplier (10) is clean and well lubricated with
dielectric grease. Grease the front
1
/
3
of the multiplier and its contact
spring if necessary.
2. Generously lubricate the outside diameter of the puller (24) and the
packing cartridge /fluid return spring (25) with MagnaLube G or an
equivalent PTFE-based lubricant.
3. Generously lubricate the inside of the fluid return spring bore in the
handle with MagnaLube G or an equivalent PTFE-based lubricant.
4. Insert the packing cartridge/fluid return spring and the end of the puller
into the handle trigger bore and mate together the handle (19) and the
extension (7).
5. Secure the extension to the handle with the four socket-head screws (8).
Tighten the screws to 1.36 − 1.58 N

m (12 − 14 in.-lb).