Nordson kinetix, Руководство пользователя

Страница: 56 / 76

Repair
7-16
Part 334598G03
E 2008 Nordson Corporation
Cable Installation
See Figure 7-9.
1. Secure the actuator switch (33) to the back cover (45) with its
screws (35) and washers (34).
NOTE: The actuator switch should be placed as shown in Figure 7-9. The
wires should be to the left of the switch and the actuator clip should be
placed behind the switch so that its arm extends along the bottom of the
switch from the right.
2. Connect the cable connector (B) to the multiplier connector (C).
NOTE: Make sure the cable is snapped into the ribbed slots in the back of
the handle.
CAUTION: Be careful not to pinch the cable between the handle and the
back cover as the back cover is tightened.
3. Secure the ground bracket (A) to the handle and back cover using the
two screws (30).
4. Secure the back cover using the screws (41). Tighten the screws to
0.9 − 1.13 N

m (8 − 10 in.-lb).
5. Secure the fluid hose fitting within the ground bracket (A) with the two
screws (52).
Fluid Supply Hose Replacement
See Figure 7-10.
Fluid Hose Removal
1. Turn off the gun control unit and ground the spray gun electrode to
remove any residual charge.
2. Turn off the fluid-delivery system and relieve the fluid pressure.
3. Remove the two screws (52) that attach the fluid hose fitting (B) to the
ground bracket (A). Remove the fluid hose from the ground bracket.
4. Loosen the hose retaining nut (C) at the extension fluid inlet boss (D),
and unscrew it completely.
5. Pull the hose assembly out of the extension.