Nordson kinetix, Руководство пользователя

Страница: 59 / 76

Repair
7-19
Part 334598G03
E
2008 Nordson Corporation
Table 7-1 Spray Gun Service Notes
Note Item Description
1
8 Tighten to 2.27 − 2.83 N

m (20 − 25 in.-lb).
2
28, 41 Tighten to 0.9 − 1.13 N

m (8 − 10 in.-lb).
3
30 Tighten to 1.36 − 1.70 N

m (12 − 15 in.-lb).
4
23 Tighten hand tight.
5
21 Tighten the retaining nut into the extension
inlet
1
/
4
turn past hand tight.
6
15 Trigger the spray gun to pull the ball tip
back before removing or installing a fluid
tip.
7
15 Tighten finger tight.
8
16, 36, 38, 43, 49, 53, 56,
18 (wire at both ends)
19 (inside the fluid return bore)
20 (end of pull shaft),
23 (inside of packing cartridge retainer)
24 (the small outside diameter)
Generously apply MagnaLube G
(PTFE-filled lubricant) to these parts.
9
18, 20, 44 Apply threadlocking adhesive to the
threads of these items.
10
10, 11, 18, 20, 21 Apply a liberal coat of dielectric grease to
these areas.
11
23 Apply a thin coat of dielectric grease to the
threads of this item.
12
22 Apply a thin coat of dielectric grease to the
outside of this item.
13
6, 9, 16 Apply dielectric grease to these O-rings.
14
10, 19 Make sure the cable is snapped into the
ribbed slots in the back of the handle.
15
15 A removable threadlocking adhesive can
be applied to the threads of the ball tip if
there are problems with the ball tip backing
out.