Nordson kinetix, Руководство пользователя

Страница: 54 / 76

Repair
7-14
Part 334598G03
E 2008 Nordson Corporation
Multiplier Installation
See Figure 7-8.
1. Remove the following items from the old multiplier and install them on
the new multiplier:
S
screws (13),
S
heat sink bracket (12)
2. Check the continuity of the new multiplier. Refer to Multiplier Continuity
and Resistance Check on page 6-5.
3. Make sure that the contact spring (11) is in place and apply a liberal
amount of dielectric grease (D) to the front
1
/
3
of the new multiplier (10)
and the contact spring.
4. Push the new multiplier through the handle (19) and into the extension.
5. Attach the heat sink bracket (12) to the handle using the screws (13).
6. Connect the cable connector (B) to the multiplier connector (C).
7. Snap the cable into the ribbed slots in the back of the handle.
CAUTION: Be careful not to pinch the cable between the handle and the
back cover as the back cover is tightened.
8. Secure the bracket to the handle and back cover using the two
screws (30).
9. Secure the back cover (45) with the screws (41). Tighten the screws to
0.9 − 1.13 N

m (8 − 10 in.-lb).
10. Secure the fluid hose within the ground bracket (A) with the two screws.
Gun Cable Replacement
See Figure 7-9.
Cable Removal
1. Turn off the gun control unit and ground the spray gun electrode to
remove any residual charge.
2. Remove the two screws (52) that attach the fluid hose fitting (D) to the
ground bracket (A). Remove the fluid hose from the ground bracket.
3. Remove the screws (30, 41) to remove the back cover (45) from the
handle and the ground bracket.
4. Slowly pull the back cover away from the handle and disconnect the
cable connector (B) from the multiplierl connector (C).
NOTE: The cable is secured in ribbed slots in the back of the handle.