Nordson DuraBlue D10L, Руководство пользователя по изделию

Страница: 27 / 164

Installation
3-1
Part 1032059B
E
2003 Nordson Corporation
Manual 41-DURABLUE-MA-02
Section 3
Installation
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Quick-Start
If you have already installed the melter using the installation guide
(P/N 1024498) that is provided inside the shipping container, and you have
no questions concerning the installation, go to Setting Up the Melter later in
this section for information about how to prepare the melter to operate with
your manufacturing process.
Overview
DuraBlue melters are factory-configured for each order and require only the
assembly and set up tasks described in this section. If your melter was
ordered as a complete system, the shipping container will also contain one
or more hot melt hoses and guns.
The melter is shipped from the factory with an installation kit that contains
components that must be assembled on the melter by the customer. Some
additional materials must also be supplied by the customer to complete the
installation.
If optional equipment was ordered with the melter, refer to the
documentation provided with the optional equipment for installation and
operating instructions.
The illustrations accompanying the procedures in this section depict the
D10L melter. Unless otherwise noted, the instructions also apply to the D4L
and D16L melters.
Additional Information
This section presents installation procedures in their most commonly used
form. Procedural variations or special considerations are explained in the
additional information table that follows most procedures. Where applicable,
some table entries also contain cross-reference information. Additional
information tables are indicated by the symbol shown to the left.