Nordson EFD BlueCure FL, Руководство по эксплуатации

Страница: 12 / 22

12
Pin Function Signal Level Remark
1 --- --- Do not connect
2 Input
Lamp output 0 to +5 V DC The desired lamp output is achieved depending on the input voltage (+5 V
= 100 %, +1 V = 20 %). The smallest input voltage for the proper
function of the lamp is +1 V.
Note: A connection with pin 6 results in 100% output in the case of Rin 10 k
Ω
3 Input
Turn on lamp
with high signal 0 or +5 V DC TTL (Transistor-Transistor-Logic):
0 to +0.4 V DC = Lamp off (open input = off)
+3.5 to +5 V DC = Lamp on
Note: Beyond the listed values, the lamp operates in an undefined
condition.
4 Input
Turn on lamp
with low signal 0 or +5 V DC TTL (Transistor-Transistor-Logic):
0 to +0.4 V DC = Lamp on
+3.5 to +5 V DC = Lamp off (open input = off)
Note: Beyond the listed values, the lamp operates in an undefined
condition.
5 Output
Temperature fault 0 or +5 V DC Open commutator TTL output:
0 to +0.4 V DC = temperature fault
+3.5 to +5 V DC = no temperature fault
Leakage current: maximum 5 mA (see diagram following this table)
Note: Beyond the listed values, the lamp operates in an undefined
condition. The pins 5 and 11 can be connected with each other for a
common error output (see explanation and diagram following this table).
The remarks regarding the use of the output under 7 Intensity of the
Radiation must also be complied with.
6 Output
+5 V DC +5 V DC The reference voltage is only intended for the operation of the lamp.
Improper use of this voltage for other purposes can cause damage to the
lamp.
Connect pin 6 with pin 2 for a constant 100% lamp output.
7 Emergency
shut-off
functionality 0 or +5 V DC For the connection to a latch circuit at the facility.
0 to +0.4 V DC = release
+3.5 to +5 V DC = no release
Note: Beyond the listed values, the lamp operates in an undefined
condition. If a latch circuit is not present at the facility, pin 7 must be
connected with a ground pin (pin 14).
8 Reference mass 0 V DC ---
9 Reference mass 0 V DC ---
10 Reference mass 0 V DC ---
11 Output
SLM error
0 or +5 V DC Open commutator TTL output:
0 to +0.4 V DC = error
+3.5 to +5 V DC = no error
Leakage current: maximum 5 mA (see diagram following this table) Note:
Beyond the listed values, the lamp operates in an undefined condition. The
pins 5 and 11 can be connected with each other for a common error
output (see explanation and diagram following this table).
12 --- --- Do not connect
13 --- --- Do not connect
14 Reference mass 0 V DC ---
15 Output
Temperature
monitor
0 to +7,5 V DC The output voltage is proportional to the SLM of the cooling element.
The value should not 5 V DC.
Conversion factor: 0.1 V/°C (e.g. +30 °C = 3.0 V DC)
5.1 SPS Connection