Nokia IP290 - Security Appliance, Руководство по установке

Страница: 43 / 81

Two-Port Fiber-Optic Gigabit Ethernet NICs
Nokia IP290 Security Platform Installation Guide 43
The long-range single-mode fiber (SMF) fiber-optic Gigabit Ethernet NICs in the IP290 run on
Nokia IPSO v4.2 or higher.
You can configure and monitor Gigabit Ethernet NIC interfaces with Nokia Network Voyager.
Specifically, you set the port speed and full-duplex mode with Network Voyager.
For information about how to access Network Voyager and the related reference materials, see
“Using Nokia Network Voyager” on page 36.
Figure 13 shows the front panel details for the two-port short-range (1000 BASE-SX) fiber-optic
Gigabit Ethernet NIC you can use in IP290 appliance.
Figure 13 PMC Two-Port Short-Range Gigabit Ethernet NIC
Figure 14 shows the front panel details for the two-port long-range (1000 BASE-LX) fiber-optic
Gigabit Ethernet NIC you can use in your IP290.
Figure 14 PMC Two-Port Long-Range Gigabit Ethernet NIC
After the power is turned on and the cables are connected, the Ethernet link LEDs on both the
IP290 and on the remote equipment illuminate to indicate the connection. As data is transmitted,
the activity LEDs on the appliance illuminate.
Fiber-Optic Gigabit Ethernet NIC Connectors and Cables
For short-range NICs, to connect the fiber-optic Gigabit Ethernet NIC to other network
components, use a multi-mode, fiber-optic cable with an LC connector for each NIC interface.
You can use either 50 or 62.5 micron cable; 50 micron-type cable provides longer transmission
reach.
00206
GIGE
Link LEDs (solid green)
Activity LEDs (blinking amber)
Ports
00555
LINK
ACT
1000B-LX
Link LEDs (solid green)
Activity LEDs (blinking amber)
Ports