Nokia IP290 - Security Appliance, Руководство по установке

Страница: 40 / 81

4
About IP290 Appliance Network Interface Cards
40 Nokia IP290 Security Platform Installation Guide
When you purchase a copper Gigabit Ethernet NIC with your IP290 appliance, the NIC is
installed before the appliance is delivered to you. For information about how to add or replace a
NIC, see
Chapter 5, “Installing and Replacing Network Interface Cards.”
Copper Gigabit Ethernet NIC Features in the IP290
The copper Gigabit Ethernet NIC supports:
„
Tracing through tcpdump
„
High bandwidth
„
Full-duplex mode operation up to 1 Gbps
„
Link speed auto advertising (10/100/1000)
„
PCI operation at 66 MHz on the IP290
„
Compliance with IEEE 802.3ab Gigabit Ethernet specifications
The copper Gigabit NICs installed in IP290 appliances run on Nokia
IPSO v4.2 or later.
You can configure and monitor Gigabit Ethernet NIC interfaces by using Nokia Network
Voyager. Specifically, you can use Network Voyager to set the port speed and full-duplex mode
to 1000, 100, or 10 Mbps.
For information about how to access Network Voyager and the related reference materials, see
“Using Nokia Network Voyager” on page 36.
Figure 10 Two-Port Copper Gigabit Ethernet NIC Front Panel
\
Note
The two-port copper Gigabit Ethernet NIC you use in IP290 appliances must be the Version
2 type, as indicated on the right end of the NIC faceplate. These NICs are sold by Nokia
under the order code NIF4425.
After the power is turned on and the cables are connected, the Ethernet Link LEDs on both the
appliance and on the remote equipment illuminate to indicate the connection.
00386.5
LINK
ACT
V2
LINK
ACT
1000BaseT
Link LEDs (green for 10/100 Mbps, or orange for 1000 Mbps)
Activity LEDs (orange)
Ports